SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|7||$52.80||  ADD TO CART|
1.1 This specification covers the requirements for rod drawing stock in diameters from 1/4 to 13/8 in. (6.4 to 35 mm) produced from electrolytic tough-pitch or oxygen-free coppers and are suitable for further fabrication into electrical conductors.
1.2 The values stated in inch-pound units are the standard. The values given in parentheses are for information only.
1.3 The following safety hazards caveat pertains only to Section 13. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
E8/E8M Test Methods for Tension Testing of Metallic Materials
E18 Test Methods for Rockwell Hardness of Metallic Materials
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
E53 Test Method for Determination of Copper in Unalloyed Copper by Gravimetry
E478 Test Methods for Chemical Analysis of Copper Alloys
E1606 Practice for Electromagnetic (Eddy-Current) Examination of Copper Redraw Rod for Electrical Purposes
E2575 Test Method for Determination of Oxygen in Copper and Copper Alloys
Other DocumentNBS Handbook 100 Copper Wire Tables
ICS Number Code 29.050 (Superconductivity and conducting materials)
UNSPSC Code 26121500(Electrical wire); 30102409(Copper rods)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM B49-98e2, Standard Specification for Copper Rod Drawing Stock for Electrical Purposes, ASTM International, West Conshohocken, PA, 1998, www.astm.orgBack to Top