ASTM B481-68(1997)

    Standard Practice for Preparation of Titanium and Titanium Alloys for Electroplating


      Format Pages Price  
    PDF 3 $45.60   ADD TO CART


    1. Scope

    1.1 This practice describes processes that have been found to be successful in producing adherent electrodeposits of good quality on titanium and certain titanium alloys. Not all of the processes that have been reported as successful are described, but rather three basic ones that have had the widest use. A rather complete listing of the published work on electroplating on titanium is given in the list of references which appear at the end of this practice.

    1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use . For a specific hazard statement, see 3.1.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B343 Practice for Preparation of Nickel for Electroplating with Nickel


    UNSPSC Code

    UNSPSC Code 12141746(Titanium Ti); 11171900(Titanium based super alloys)


    Referencing This Standard

    DOI: 10.1520/B0481-68R97

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM B481-68(1997), Standard Practice for Preparation of Titanium and Titanium Alloys for Electroplating, ASTM International, West Conshohocken, PA, 1997, www.astm.org

    Back to Top