1.1 This specification establishes the requirements for seamless copper-nickel pipe and tube in straight lengths, suitable for general engineering purposes. The alloys involved are copper alloys UNS Nos. C70400, C70600, C70620, C71000, C71500, C71520, and C72200.
1.1.1 Copper alloys UNS Nos. C70620 and C71520 are intended for product that will be subsequently welded.
1.2 Units—The values stated in inch-pound or SI units are to be regarded separately as standard. The values in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
1.3 The following safety hazard caveat pertains only to the test methods described in the Test Methods section of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B153 Test Method for Expansion (Pin Test) of Copper and Copper-Alloy Pipe and Tubing
B251 Specification for General Requirements for Wrought Seamless Copper and Copper-Alloy Tube
B251M Specification for General Requirements for Wrought Seamless Copper and Copper-Alloy Tube (Metric)
B846 Terminology for Copper and Copper Alloys
B950 Guide for Editorial Procedures and Form of Product Specifications for Copper and Copper Alloys
E8 Test Methods for Tension Testing of Metallic Materials
E8M Test Methods for Tension Testing of Metallic Materials [Metric]
E18 Test Methods for Rockwell Hardness of Metallic Materials
E54 Test Methods for Chemical Analysis of Special Brasses and Bronzes
E62 Test Methods for Chemical Analysis of Copper and Copper Alloys (Photometric Methods)
E75 Test Methods for Chemical Analysis of Copper-Nickel and Copper-Nickel-Zinc Alloys
E76 Test Methods for Chemical Analysis of Nickel-Copper Alloys
E118 Test Methods for Chemical Analysis of Copper-Chromium Alloys
E243 Practice for Electromagnetic (Eddy-Current) Examination of Copper and Copper-Alloy Tubes
E478 Test Methods for Chemical Analysis of Copper Alloys
copper-nickel; pipe; seamless; tube; UNS No. C70400; UNS No. C70600; UNS No. C70620; UNS No. C71000; UNS No. C71500; UNS No. C71520; UNS No. C72200; Seamless Cu/Cu alloy tube--specifications; UNS C70400 (copper-nickel, 5 %); UNS C70600 (Cu-Ni)--pipe/tube (seamless/welded); UNS C71000--pipe and tube; UNS C71500--pipe/tube (seamless/welded); UNS C72200 (copper nickel); Copper alloy pipe--specifications; Copper alloy tube--specifications; Copper-nickel alloys--specifications; Incoloy/Inconel; Seamless Cu/Cu alloy pipe--specifications
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]