1.1 This specification establishes the requirements for extruded leaded-brass angles, channels, and other architectural shapes of solid cross section produced in Copper Alloy UNS Nos. C38000 and C38500.
1.1.1 Pipe, tube, or other hollow section products are not included in this specification.
1.2 Units—The values stated in inch-pound units are the standard. The values given in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B249/B249M Specification for General Requirements for Wrought Copper and Copper-Alloy Rod, Bar, Shapes and Forgings
B601 Classification for Temper Designations for Copper and Copper Alloys--Wrought and Cast
B846 Terminology for Copper and Copper Alloys
B950 Guide for Editorial Procedures and Form of Product Specifications for Copper and Copper Alloys
E8 Test Methods for Tension Testing of Metallic Materials
E54 Test Methods for Chemical Analysis of Special Brasses and Bronzes
E255 Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition
E478 Test Methods for Chemical Analysis of Copper Alloys
architectural extruded shapes; extruded shapes; leaded brass extruded shapes; UNS No.C38000; UNS No. C38500; Copper alloy rod/bar/shapes--specifications; Architectural extruded shapes; Leaded brass extruded shapes; Brass--leaded brass; Lead metals/alloys--specifications; UNS C38000 (leaded brass); UNS C38500 (architectural bronze); UNS N06102 (Ni-Cr alloy, IN-102);
ICS Number Code 77.150.30 (Copper products)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]