1. Scope
1.1 This specification establishes the requirements for extruded leaded-brass angles, channels, and other architectural shapes of solid cross section produced in Copper Alloy UNS Nos. C38000 and C38500.
1.1.1 Pipe, tube, or other hollow section products are not included in this specification.
1.2 Units—The values stated in inch-pound units are the standard. The values given in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered standard.
2. Referenced Documents
B249/249M Specification for General Requirements for Wrought Copper and Copper Alloy Rod, Bar, Shapes, and Forgings
B601 Classification for Temper Designations for Copper and Copper Alloys-Wrought and Cast
B846 Terminology for Copper and Copper Alloys
E255 Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition
E478 Test Methods for Chemical Analysis for Copper Alloys
E54 Test Methods for Chemical Analysis of Special Brasses and Bronzes
E8 Test Methods for Tension Testing of Metallic Materials
Index Terms
architectural extruded shapes; extruded shapes; leaded brass extruded shapes; Number Code 77.150.30 (Copper products)
DOI: 10.1520/B0455-01
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
