1. Scope
1.1 This specification covers nickel-chromium-molybdenum-columbium (UNS N06625), nickel-chromium-molybdenum-silicon alloy (UNS N06219), and Nickel-Chromium-Molybdenum-Tungsten Alloy (UNS N06650)* in the form of hot-worked rod and bar and cold-worked rod in the conditions shown in Table 1.
1.1.1 UNS N06625 products are furnished in two grades of different heat-treated conditions:
Grade 1 (Annealed)—Material is normally employed in service temperatures up to 1100°F (593°C).
Grade 2 (Solution Annealed)—Material is normally employed in service temperatures above 1100°F (593°C) when resistance to creep and rupture is required.
Note 1—Hot-working or reannealing may change properties significantly, depending on working history and temperatures.
<>1.1.2 Alloys UNS N06219 and UNS N06650 are supplied in solution annealed condition only.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 The following precautionary caveat pertains only to the test methods portion, Section 12, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
B443 Specification for Nickel-Chromium-Molybdenum-Columbium Alloy(UNS N06625) and Nickel-Chromium-Molybdenum-SiliconAlloy (UNS N06219) Plate, Sheet, and Strip
B880 Specification for General Requirements for Chemical Check Analysis Limits for Nickel, Nickel Alloys and Cobalt Alloys
E8 Test Methods for Tension Testing of Metallic Materials
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
E1473 Test Methods for Chemical Analysis of Nickel, Cobalt, and High-Temperature Alloys
Keywords
bar; rod; UNS N06625; UNS N06219; UNS N06650; Nickel-chromium alloys--specifications; Nickel-chromium-molybdenum-columbium alloys--specifications; Udimet alloy; UNS N06625 (Ni-Cr alloy, Inconel 625); Nickel alloy rod/bar/wire--specifications;
ICS Code
ICS Number Code 77.150.40 (Nickel and chromium products)
DOI: 10.1520/B0446-02
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
