ASTM B444-04

    Standard Specification for Nickel-Chromium-Molybdenum-Columbium Alloys (UNS N06625) and Nickel-Chromium-Molybdenum-Silicon Alloy (UNS N06219) Pipe and Tube


      Format Pages Price  
    PDF 3 $48.00   ADD TO CART


    1. Scope

    1.1 This specification covers nickel-chromium-molybdenum-columbium alloys (UNS N06625 and UNS N06852) and nickel-chromium-molybdenum-silicon alloy (UNS N06219)* in the form of cold-worked seamless pipe and tube. The general requirements for pipe and tube are covered by Specification B 829.

    1.1.1 UNS N06625 products are furnished in two grades of different heat-treated conditions:

    Grade 1 (annealed)

    Material is normally employed in service temperatures up to 1100°F (593°C).

    Grade 2 (solution annealed)

    Material is normally employed in service temperatures above 1100°F (593°C) when resistance to creep and rupture is required. Note 1

    Hot-working or reannealing may change properties significantly, depending on working history and temperatures.

    1.1.2 Alloys UNS N06219 and UNS N06852 are supplied in the solution annealed condition only.

    1.2 The following precautionary caveat pertains only to the test methods portion, Section , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B829 Specification for General Requirements for Nickel and Nickel Alloys Seamless Pipe and Tube

    E112 Test Methods for Determining Average Grain Size

    G28 Test Methods for Detecting Susceptibility to Intergranular Corrosion in Wrought, Nickel-Rich, Chromium-Bearing Alloys

    G48 Test Methods for Pitting and Crevice Corrosion Resistance of Stainless Steels and Related Alloys by Use of Ferric Chloride Solution


    ICS Code

    ICS Number Code 77.150.40 (Nickel and chromium products)

    UNSPSC Code

    UNSPSC Code 11101711(Non ferrous alloy)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B0444-04

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM B444-04, Standard Specification for Nickel-Chromium-Molybdenum-Columbium Alloys (UNS N06625) and Nickel-Chromium-Molybdenum-Silicon Alloy (UNS N06219) Pipe and Tube, ASTM International, West Conshohocken, PA, 2004, www.astm.org

    Back to Top