ASTM B444-00e1

1.1 This specification covers nickel-chromium-molybdenum-columbium alloy (UNS N06625) and nickel-chromium-molybdenum-silicon alloy (UNS N06219)* in the form of cold-worked seamless pipe and tube. The general requirements for pipe and tube are covered by Specification B829.

1.1.1 UNS N06625 products are furnished in two grades of different heat-treated conditions:

Grade 1 (annealed)--Material is normally employed in service temperatures up to 1100^oF (593C).

Material is normally employed in service temperatures above 1100^oF (593^oC) when resistance to creep and rupture is required.

Note 1--Hot-working or reannealing may change properties significantly, depending on working history and temperatures.

1.1.2 Alloy UNS N06219 is supplied in solution annealed condition only.

1.2 The following precautionary caveat pertains only to the test methods portion, Section 9, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

Keywords

seamless pipe; seamless tube; N06219; N06625; Nickel alloy pipe--specifications; Nickel alloy tube--specifications; Nickel-chromium alloys--specifications; Nickel-chromium-molybdenum-columbium alloys--specifications; Udimet alloy; UNS N06219 (Ni-Cr-Mo-Si alloy, Nicrofer 6219Si); UNS N06625 (Ni-Cr alloy, Inconel 625) ; ICS Number Code 6625; 77.150.40 (Nickel and chromium products)

ICS Code

ICS Number Code 77.150.40 (Nickel and chromium products)

Citing ASTM Standards

[Back to Top]