1. Scope
1.1 This specification covers rolled nickel-chromium-molybdenum-columbium alloy (UNS N06625) and nickel-chromium-molybdenum-silicon alloy (UNS N06219)* plate, sheet, and strip.
1.1.1 Alloy UNS N06625 products are furnished in two grades of different heat-treated conditions:
Grade 1 (Annealed)Material is normally employed in service temperatures up to 1100F (593C).
Grade 2 (Solution Annealed)Material is normally employed in service temperatures above 1100F (593C) when resistance to creep and rupture is required. Note 1
Hot-working or reannealing may change properties significantly, depending on working history and temperatures.
1.1.2 Alloy UNS N06219 is supplied in solution annealed condition only.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
B446 Specification for Nickel-Chromium-Molybdenum-Columbium Alloy (UNS N06625), Nickel-Chromium-Molybdenum-Silicon Alloy (UNS N06219), and Nickel-Chromium-Molybdenum-Tungsten Alloy (UNS N06650) Rod and Bar
B880 Specification for General Requirements for Chemical Check Analysis Limits for Nickel, Nickel Alloys and Cobalt Alloys
E8 Test Methods for Tension Testing of Metallic Materials
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
E1473 Test Methods for Chemical Analysis of Nickel, Cobalt, and High-Temperature Alloys
Keywords
UNS N06219; UNS N06625; plate; sheet; strip; Nickel-chromium-molybdenum-silicon alloys--specifications; Rolled nickel-chromium-molybdenum-columbium alloys; Udimet alloy; UNS N06219 (Ni-Cr-Mo-Si alloy, Nicrofer 6219Si); UNS N06625 (Ni-Cr alloy, Inconel 625); Nickel alloy plate/sheet/strip--specifications; Nickel-chromium alloys--specifications; Nickel-chromium-molybdenum-columbium alloys--specifications;
ICS Code
ICS Number Code 77.150.40 (Nickel and chromium products)
DOI: 10.1520/B0443-00R05
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
