ASTM B369-06

1.1 This specification establishes the requirements for copper-nickel alloy castings with nominal compositions shown in Table 1. These are as follows:

1.2 Castings of these alloys are used primarily for corrosion-resistance applications such as in construction and for pressure vessels, particularly in marine pumps, valves, and fittings.

1.3 These alloys are considered weldable, but they may be ordered with a weld test to ensure weldability. When extensive welding is to be performed on the casting, weldability tests should be specified in the ordering information (4.2.6) to ensure proper welding characteristics.

1.4 UnitsValues stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered standard.

The following hazard statement applies only to Section 7, Weldability Test, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM Standards

ASME Code

AWS Standard

Keywords

copper-alloy castings; copper-nickel castings ; UNS No. C96200; UNS No. C96400; Copper alloy castings--specifications; UNS C96200 (cast copper-nickel); UNS C96400 (cast copper nickel); ICS Number Code 6400; 77.150.30 (Copper products)

ICS Code

Citing ASTM Standards

[Back to Top]