ASTM B361-95

    Standard Specification for Factory-Made Wrought Aluminum and Aluminum-Alloy Welding Fittings

    SUPERSEDED (see Active link, below)


    There is no PDF download available at this time, however you may purchase a copy of this document from the IHS Standards Store
    (Click here to view IHS phone and email contact details).



    1. Scope

    1.1 This specification covers only factory-made wrought aluminum and aluminum-alloy welding fittings in contrast to field-made fittings. The term "welding fittings" applies to butt-welding or socket-end parts, such as 45° elbows, 180° return bends, 90° short radius elbows, and other types made to the dimensional standards specified by ANSI B16.9, B16.11, and B16.28.

    Note 1-Throughout this specification use of the term alloy in the general sense includes aluminum as well as aluminum-alloy.

    1.2 For acceptance criteria for inclusion of new aluminum and aluminum alloys in this specification, see Annex A1.

    1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B209 Specification for Aluminum and Aluminum-Alloy Sheet and Plate

    B210 Specification for Aluminum and Aluminum-Alloy Drawn Seamless Tubes

    B211 Specification for Aluminum and Aluminum-Alloy Rolled or Cold Finished Bar, Rod, and Wire

    B221 Specification for Aluminum and Aluminum-Alloy Extruded Bars, Rods, Wire, Profiles, and Tubes

    B234 Specification for Aluminum and Aluminum-Alloy Drawn Seamless Tubes for Condensers and Heat Exchangers

    B241/B241M Specification for Aluminum and Aluminum-Alloy Seamless Pipe and Seamless Extruded Tube

    B247 Specification for Aluminum and Aluminum-Alloy Die Forgings, Hand Forgings, and Rolled Ring Forgings

    B660 Practices for Packaging/Packing of Aluminum and Magnesium Products

    B881 Terminology Relating to Aluminum- and Magnesium-Alloy Products

    D3951 Practice for Commercial Packaging

    ANSI Standards

    H35.1/H35.1(M) Alloy and Temper Designation Systems for Aluminum Available from Aluminum Association, Inc., 1525 Wilson Blvd., Suite 600, Arlington, VA 22209, http://www.aluminum.org.

    ASME Standards

    SectionIX Boiler and Pressure Vessel Code

    AWS Standards

    AWSD10.7M/D10.7 Recommended Practices for Gas Shielded-Arc Welding of Aluminum and Aluminum-Alloy Pipe Available from American Welding Society (AWS), 550 NW LeJeune Rd., Miami, FL 33126, http://www.aws.org.

    Federal Standards

    Fed.Std.No.123 Marking for Shipment (Civil Agencies) Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http://www.dodssp.daps.mil.


    ICS Code

    ICS Number Code 23.040.40 (Metal fittings)

    UNSPSC Code

    UNSPSC Code 11172000(Aluminum based alloys); 40183100(Tube fittings)


    DOI: 10.1520/B0361-95

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top