1.1 This specification covers nickel-coated, soft or annealed, round copper wire for use in electrical equipment.
1.2 Five classes of wire are covered as follows:
1.2.1 Class 2 -Wire whose nickel coating is at least 2% of the total weight of the coated wire.
1.2.2 Class 4 -Wire whose nickel coating is at least 4% of the total weight of the coated wire.
1.2.3 Class 7 -Wire whose nickel coating is at least 7% of the total weight of the coated wire.
1.2.4 Class 10 -Wire whose nickel coating is at least 10% of the total weight of the coated wire.
1.2.5 Class 27 -Wire whose nickel coating is at least 27% of the total weight of the coated wire. Note 1-For information purposes, the thickness of coating in microinches provided by the percentages listed in 1.2 is shown in Table 1.
1.3 The SI values for density and resistivity are to be regarded as the standard. For all other properties the inch-pound values are to be regarded as the standard and the SI units may be approximate.
1.4 This hazard statement applies only to Section 6, Test Methods, and to the Appendix of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B49 Specification for Copper Rod Drawing Stock for Electrical Purposes
B193 Test Method for Resistivity of Electrical Conductor Materials
B258 Specification for Nominal Diameters and Cross-Sectional Areas of AWG Sizes of Solid Round Wires Used as Electrical Conductors
E75 Test Methods for Chemical Analysis of Copper-Nickel and Copper-Nickel-Zinc Alloys
NBS Handbook 100--Copper Wire Tables Available from National Technical Information Service (NTIS), 5301 Shawnee Rd., Alexandria, VA 22312, http://www.ntis.gov.
coated copper wire; copper electrical conductor; copper wire; electrical conductor; electrical conductor-copper; nickel-coated copper wire; nickel-coated soft or annealed copper wire; soft copper wire;: Annealed copper--specifications; Coated copper wire; Copper electrical conductors--specifications; Electrical conductors--copper; Metallic coatings--specifications; Nickel coatings--specifications; Soft copper electrical wire;
ICS Number Code 77.150.30 (Copper products)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]