ASTM B351-01

    Standard Specification for Hot-Rolled and Cold-Finished Zirconium and Zirconium Alloy Bars, Rod, and Wire for Nuclear Application


    There is no PDF download available at this time, however you may purchase a copy of this document from the IHS Standards Store
    (Click here to view IHS phone and email contact details).



    1. Scope

    1.1 This specification covers hot- and cold-finished zirconium and zirconium alloy bars, rod, and wire, other than those required for reforging, including rounds, squares, and shapes.

    1.2 One unalloyed grade and three alloy grades for use in nuclear applications are described.

    1.3 The products covered include the following sections and sizes:

    Bars:
    Rounds, squares and hexagons Flats3/8 in. (9.5 mm) and over in diameter or size 1/ 4 to 10 in. (6.4 to 250 mm) incl in width and 1/8 in. (3.2 mm) and over in thicknessA
    Rod:
    Rounds in coils for subsequent reworking1/4 to 3/4 in. (6.4 to 19 mm) in diameter
    Wireless than 3/8 in. (9.5 mm) in diameter or size
    AThickness 1/8 in. (3.2 mm) to under 3/16 in. (4.8 m) can be cold-rolled strip as well as bar.

    1.4 Unless a single unit is used, for example corrosion mass gain in mg/dm2, the values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore each system must be used independently of the other. SI values cannot be mixed with inch-pound values.

    1.5 The following precautionary caveat pertains only to the test method portions of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    ICS Code

    ICS Number Code 77.140.60 (Steel bars and rods); 77.140.65 (Steel wire, wir ropes and link chains)

    UNSPSC Code

    UNSPSC Code 30102402(Non ferrous alloy rods)


    Referencing This Standard

    DOI: 10.1520/B0351-01

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM B351-01, Standard Specification for Hot-Rolled and Cold-Finished Zirconium and Zirconium Alloy Bars, Rod, and Wire for Nuclear Application, ASTM International, West Conshohocken, PA, 2001, www.astm.org

    Back to Top