ASTM B331-95

    Standard Test Method for Compressibility of Metal Powders in Uniaxial Compaction

      Format Pages Price  
    PDF 4 $48.00   ADD TO CART

    1. Scope

    1.1 This test method covers determination of compressibility of metal powders as measured by the extent to which they can be densified in a specified die under controlled conditions.

    1.2 The values stated in inch-pound units are to be regarded as the standard. The SI equivalents are in parentheses and may be approximate.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B215 Practices for Sampling Metal Powders

    B243 Terminology of Powder Metallurgy

    B925 Practices for Production and Preparation of Powder Metallurgy (PM) Test Specimens

    B962 Test Methods for Density of Compacted or Sintered Powder Metallurgy (PM) Products Using Archimedes Principle

    E456 Terminology Relating to Quality and Statistics

    UNSPSC Code

    UNSPSC Code

    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/B0331-95

    ASTM International is a member of CrossRef.

    Citation Format

    ASTM B331-95, Standard Test Method for Compressibility of Metal Powders in Uniaxial Compaction, ASTM International, West Conshohocken, PA, 1995,

    Back to Top