ASTM B312-96(2002)

    Standard Test Method for Green Strength for Compacted Metal Powder Specimens


      Format Pages Price  
    PDF 4 $45.60   ADD TO CART


    1. Scope

    1.1 This test method covers determination of the green strength of unsintered compacted metal powder specimens by subjecting them to a uniformly increasing transverse loading under controlled conditions. The term green strength, as used herein, defines the stress, calculated from the flexure formula, required to break a specimen as a simple beam supported near the ends and applying the force midway between the fixed line center of the supports.

    1.2 The values stated in inch-pound units are to be regarded as the standard. The SI equivalents are in parentheses and may be approximate.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B215 Practices for Sampling Metal Powders

    B243 Terminology of Powder Metallurgy

    B528 Test Method for Transverse Rupture Strength of Powder Metallurgy (PM) Specimens

    B925 Practices for Production and Preparation of Powder Metallurgy (PM) Test Specimens

    B962 Test Methods for Density of Compacted or Sintered Powder Metallurgy (PM) Products Using Archimedes Principle

    E691 Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method


    ICS Code

    ICS Number Code 77.160 (Powder metallurgy)

    UNSPSC Code

    UNSPSC Code


    Referencing This Standard

    DOI: 10.1520/B0312-96R02

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM B312-96(2002), Standard Test Method for Green Strength for Compacted Metal Powder Specimens, ASTM International, West Conshohocken, PA, 1996, www.astm.org

    Back to Top