SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|4||$48.00||  ADD TO CART|
1.1 This practice is intended to serve as a guide for the proper preparation of copper and its alloys for electroplating and conversion coating. This practice is also suitable for use before autocatalytic plating. Only alloys containing at least 50 mass % copper are considered within the scope of this practice.
1.2 The wide variety of methods of mechanical finishing are not considered strictly as preparation for electroplating or conversion coating and consequently are described only briefly.
1.3 Details of electroplating and subsequent treatments for applying conversion coatings are not within the scope of this practice.
1.4 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific precautionary statement, see 6.5.2.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
D322 Test Method for Gasoline Diluent in Used Gasoline Engine Oils by Distillation
ICS Number Code 25.220.10 (Surface preparation)
UNSPSC Code 12141711(Copper Cu)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM B281-88(2001), Standard Practice for Preparation of Copper and Copper-Base Alloys for Electroplating and Conversion Coatings, ASTM International, West Conshohocken, PA, 1988, www.astm.orgBack to Top