ASTM B272-96

    Standard Specification for Copper Flat Products with Finished (Rolled or Drawn) Edges (Flat Wire and Strip)


      Format Pages Price  
    PDF 6 $51.60   ADD TO CART


    1. Scope

    1.1 This specification establishes the requirements for copper products, flat wire and strip, with rolled or drawn finished edges produced for general application.

    1.1.1 The product is produced in UNS Copper Nos. C10100, C10200, C10300, C10500, C10700, C10800, C11000, C12200, and C14200 unless otherwise established by agreement between manufacturer and purchaser.

    1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are for information only.

    Note 1—When a copper other than that listed in 1.1.1 is designated by the purchaser, the resulting product shall conform to the physical, mechanical, performance, dimensional, and tolerance requirements per agreement between the manufacturer and purchaser.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B49 Specification for Copper Rod Drawing Stock for Electrical Purposes

    B170 Specification for Oxygen-Free Electrolytic Copper--Refinery Shapes

    B193 Test Method for Resistivity of Electrical Conductor Materials

    B248 Specification for General Requirements for Wrought Copper and Copper-Alloy Plate, Sheet, Strip, and Rolled Bar

    B250/B250M Specification for General Requirements for Wrought Copper Alloy Wire

    B577 Test Methods for Detection of Cuprous Oxide (Hydrogen Embrittlement Susceptibility) in Copper

    B846 Terminology for Copper and Copper Alloys

    B950 Guide for Editorial Procedures and Form of Product Specifications for Copper and Copper Alloys

    E8/E8M Test Methods for Tension Testing of Metallic Materials

    E18 Test Methods for Rockwell Hardness of Metallic Materials

    E53 Test Method for Determination of Copper in Unalloyed Copper by Gravimetry

    E62 Test Methods for Chemical Analysis of Copper and Copper Alloys (Photometric Methods)

    E290 Test Methods for Bend Testing of Material for Ductility

    E478 Test Methods for Chemical Analysis of Copper Alloys


    ICS Code

    ICS Number Code 77.150.30 (Copper products)

    UNSPSC Code

    UNSPSC Code 30262400(Copper ingots strip billets and coil); 31152304(Copper or copper alloy wire)


    Referencing This Standard

    DOI: 10.1520/B0272-96

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM B272-96, Standard Specification for Copper Flat Products with Finished (Rolled or Drawn) Edges (Flat Wire and Strip), ASTM International, West Conshohocken, PA, 2001, www.astm.org

    Back to Top