ASTM B263-04(2010)

    Historical Standard: ASTM B263-04(2010) Standard Test Method for Determination of Cross-Sectional Area of Stranded Conductors

    SUPERSEDED (see Active link, below)


    Buy Standard (PDF)
    3 pages
    $44.40

    Active (view current version of standard)


    1. Scope

    1.1 This test method covers the procedure for determining the cross-sectional area of stranded conductors by the mass method.

    1.2 The values stated in inch-pound or SI units are to be regarded separately as the standard. The values in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B830 Specification for Uniform Test Methods and Frequency


    UNSPSC Code

    UNSPSC Code 26121500(Electrical wire)


    DOI: 10.1520/B0263-04R10

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top