1.1 This guide is intended as an aid in establishing and maintaining a procedure for preparing zinc alloy die castings for electroplating and conversion coatings. It is primarily intended for the preparation of Alloys UNS Z33521 (AG40A) and UNS Z35530 (AC-41A) (Specification B86) for electroplating with copper, nickel, and chromium (Specification B456).
1.2 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B6 Specification for Zinc
B86 Specification for Zinc and Zinc-Aluminum (ZA) Alloy Foundry and Die Castings
B456 Specification for Electrodeposited Coatings of Copper Plus Nickel Plus Chromium and Nickel Plus Chromium
MIL-S-13165C Shot Peening of Metal Parts Available from Standardization Documents Order Desk, Bldg. 4 Section D, 700 Robbins Ave., Philadelphia, PA 19111-5094, Attn: NPODS.
Chromate coatings; Conversion coatings; Die casting zinc alloys; Electroplated coatings; Specimen preparation (general)--electroplating; Zinc die casting alloy
ICS Number Code 77.150.60 (Lead, zinc and tin products)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]