1. Scope
1.1 This specification covers commercial zinc and zinc-aluminum (ZA) alloys in ingot form for remelting for the manufacture of pressure die castings, foundry castings and continuous cast bar stock as designated and specified in Table 1. Seven alloy compositions are specified, designated as follows:
CommonTraditionalASTMAUNSA
|
Alloy 3Zamak 3AG 40AZ33521
Alloy 7Zamak 7AG 40BZ33522
Alloy 5Zamak 5AC 41AZ35530
Alloy 2Zamak 2AC 43AZ35540
ZA-8ZA-8...Z35635
ZA-12ZA-12...Z35630
ZA-27ZA-27...Z35840
|
ASee Table 1, footnote B.
1.2 Zinc alloys Z33521, Z33522, Z35530, and Z35540 are used primarily for remelting in the manufacture of pressure die castings. Zinc-aluminum alloys Z35635, Z35630, and Z35840 are used for remelting in the manufacture of both foundry and pressure die castings. Castings made from these ingots are specified in Specification B 86, Standard Specification for Zinc and Zinc-Aluminum Alloys for Foundry and Die Castings.
1.3 The values stated in inch-pound units are to be regarded as standard.
1.4 Systems of nomenclature used to designate zinc and zinc-aluminum (ZA) alloys used for casting are described in Appendix X1.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ISO Standards
ISO3815–2 Zinc and zinc alloys -- Part 2: Analysis by inductively coupled plasma optical emission spectrometry.
ASTM Standards
B86 Specification for Zinc and Zinc-Aluminum (ZA) Alloy Foundry and Die Castings
B275 Practice for Codification of Certain Nonferrous Metals and Alloys, Cast and Wrought
B897 Specification for Configuration of Zinc and Zinc Alloy Jumbo Block and Half Block Ingot
B899 Terminology Relating to Non-ferrous Metals and Alloys
B908 Practice for the Use of Color Codes for Zinc Casting Alloy Ingot
B949 Specification for General Requirements for Zinc and Zinc Alloy Products
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
E536 Test Methods for Chemical Analysis of Zinc and Zinc Alloys
Keywords
bar stock; castings; concast; continuous cast bar stock; die castings; foundry castings; permanent mold castings; pressure die castings; prototyping; sand castings; ZA alloys; Zamak; zinc; zinc-aluminum alloys; zinc metal; Zinc alloys--specifications; Zinc die casting alloy; Die casting zinc alloys--specifications; Ingots; Pressure die castings; UNS Z33521 (Zn alloy AG40A); UNS Z33522 (Zn alloy); UNS Z33530 (Zn alloy AC41A); UNS Z35540 (Zn alloy, AC43A); Zinc--specifications; Zinc alloy ingots
ICS Code
DOI: 10.1520/B0240-05
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
