1.1 This specification covers aluminum 1350-H19 (extra hard) round wire for electrical purposes.
1.2 The values stated in inch-pound or SI units are to be regarded separately as standard. The values in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
1.2.1 For density, resistivity, and temperature, the values stated in SI units are to be regarded as standard.
Note 1—lPrior to 1975 aluminum 1350 was designated EC aluminum.
Note 2—The aluminum and temper designations conform to ANSI H35.1/H35.1M. Aluminum 1350 corresponds to UNS A91350 in accordance with Practice E 527.Note 3
For definitions of terms found in this specification relating to uninsulated electrical conductors see Terminology B 354.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B193 Test Method for Resistivity of Electrical Conductor Materials
B233 Specification for Aluminum 1350 Drawing Stock for Electrical Purposes
B354 Terminology Relating to Uninsulated Metallic Electrical Conductors
B557 Test Methods for Tension Testing Wrought and Cast Aluminum- and Magnesium-Alloy Products
B557M Test Methods for Tension Testing Wrought and Cast Aluminum- and Magnesium-Alloy Products (Metric)
B830 Specification for Uniform Test Methods and Frequency
E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
ANSIH35.1M American National Standard for Alloy and Temper Systems for Aluminum [Metric]
NBS Handbook 100-Copper Wire Tables Available from National Institute of Standards and Technology (NIST), 100 Bureau Dr., Stop 1070, Gaithersburg, MD 20899-1070, http://www.nist.gov.
aluminum electrical conductor; aluminum wire; electrical conductor; wire;
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]