SUPERSEDED (click for Active standard)
1.1 This specification establishes requirements for bronze castings for turntables, movable bridges and bridge parts, and bronze castings suitable for use in bridges and other structures for fixed and expansion bearings where motion is slow and intermittent. Historically the alloys in this specification have been used in the applications listed in Appendix X1. Actual practice may vary.
1.2 The values stated in inch-pound units are the standard. SI values given in parentheses are for information only.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B208 Practice for Preparing Tension Test Specimens for Copper Alloy Sand, Permanent Mold, Centrifugal, and Continuous Castings
B824 Specification for General Requirements for Copper Alloy Castings
B846 Terminology for Copper and Copper Alloys
E9 Test Methods of Compression Testing of Metallic Materials at Room Temperature
E10 Test Method for Brinell Hardness of Metallic Materials
E255 Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition
E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
ICS Number Code 77.150.30 (Copper products)
UNSPSC Code 31100000(Castings and casting assemblies); 24101711(Turntables)
ASTM B22-95, Standard Specification for Bronze Castings for Bridges and Turntables, ASTM International, West Conshohocken, PA, 1995, www.astm.orgBack to Top