ASTM B200-85(1999)

    Standard Specification for Electrodeposited Coatings of Lead and Lead-Tin Alloys on Steel and Ferrous Alloys

    SUPERSEDED (see Active link, below)


      Format Pages Price  
    PDF 6 $50.40   ADD TO CART


    1. Scope

    1.1 This specification covers the requirements for electrodeposited coatings of lead and lead-tin alloys on steel and ferrous alloys. The coatings of lead-tin alloys are those that range in tin content up to but not exceeding 15 mass%. The coatings ranging between 3 and 15 mass% in tin content are known also as "terne" metallic electrodeposits.

    1.2 This specification does not apply to sheet, strip, or wire in the unfabricated form.

    1.3 The following precautionary caveat pertains only to the test method portion, Section 11, of this specification: This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B117 Practice for Operating Salt Spray (Fog) Apparatus

    B183 Practice for Preparation of Low-Carbon Steel for Electroplating

    B242 Guide for Preparation of High-Carbon Steel for Electroplating

    B320 Practice for Preparation of Iron Castings for Electroplating

    B322 Guide for Cleaning Metals Prior to Electroplating

    B339 Specification for Pig Tin

    B374 Terminology Relating to Electroplating

    B487 Test Method for Measurement of Metal and Oxide Coating Thickness by Microscopical Examination of Cross Section

    B499 Test Method for Measurement of Coating Thicknesses by the Magnetic Method: Nonmagnetic Coatings on Magnetic Basis Metals

    B504 Test Method for Measurement of Thickness of Metallic Coatings by the Coulometric Method

    B507 Practice for Design of Articles to Be Electroplated on Racks

    B567 Test Method for Measurement of Coating Thickness by the Beta Backscatter Method

    B568 Test Method for Measurement of Coating Thickness by X-Ray Spectrometry

    B571 Practice for Qualitative Adhesion Testing of Metallic Coatings

    B602 Test Method for Attribute Sampling of Metallic and Inorganic Coatings

    B697 Guide for Selection of Sampling Plans for Inspection of Electrodeposited Metallic and Inorganic Coatings


    ICS Code

    ICS Number Code 25.220.40 (Metallic coatings)

    UNSPSC Code

    UNSPSC Code


    DOI: 10.1520/B0200-85R99

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top