ASTM B2-00(2005)e1

    Standard Specification for Medium-Hard-Drawn Copper Wire


      Format Pages Price  
    PDF 4 $45.60   ADD TO CART


    1. Scope

    1.1 This specification covers medium-hard-drawn round copper wire for electrical purposes (see Explanatory Note 0).

    1.2 The SI values of density and resistivity are to be regarded as standard. For all other properties the inch-pound values are to be regarded as standard, and the SI units may be approximate.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B49 Specification for Copper Rod Drawing Stock for Electrical Purposes

    B193 Test Method for Resistivity of Electrical Conductor Materials

    B258 Specification for Nominal Diameters and Cross-Sectional Areas of AWG Sizes of Solid Round Wires Used as Electrical Conductors

    Other Documents

    NBSHandbook100 Copper Wire Tables of the National Bureau of Standards Available from National Institute of Standards and Technology (NIST), 100 Bureau Dr., Stop 1070, Gaithersburg, MD 20899-1070, http://www.nist.gov.


    ICS Code

    ICS Number Code 77.150.30 (Copper products)

    UNSPSC Code

    UNSPSC Code 26121517(Copper wire)


    Referencing This Standard

    DOI: 10.1520/B0002-00R05E01

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM B2-00(2005)e1, Standard Specification for Medium-Hard-Drawn Copper Wire, ASTM International, West Conshohocken, PA, 2005, www.astm.org

    Back to Top