Standard Historical Last Updated: Jun 17, 2016 Track Document
ASTM B187/B187M-15

Standard Specification for Copper, Bus Bar, Rod, and Shapes and General Purpose Rod, Bar, and Shapes

Standard Specification for Copper, Bus Bar, Rod, and Shapes and General Purpose Rod, Bar, and Shapes B0187_B0187M-15 ASTM|B0187_B0187M-15|en-US Standard Specification for Copper, Bus Bar, Rod, and Shapes and General Purpose Rod, Bar, and Shapes Standard new BOS Vol. 02.01 Committee B05
$ 75.00 In stock

Abstract

This specification establishes the requirements for copper conductor bars, rods, and shapes for both electrical (bus) and general applications. Products shall be produced in tempers O60 (soft annealed), and H04 (hard). Products shall be sampled and prepared, then tested accordingly to examine their conformance to dimensional (mass, diameter, thickness, width, shape, specified and stock lengths, straightness, edge contour, and radius of edges or corners), mechanical (tensile, yield and bend strengths, elongation, Rockwell hardness, and embrittlement), electrical resistivity, and chemical composition requirements.

Scope

1.1 This specification2 establishes the requirements for copper conductor bar, rod, and shapes for electrical (bus) applications and rod, bar, and shapes for general applications.

1.1.1 The products for electrical (bus) applications shall be made from the following coppers:3

Copper UNS No.3

Reference Designation

 

 

 

 

C10100

 

OFE

 

C10200

 

OF

 

C10300

 

OFXLP

 

C10400, C10500, C10700

 

OFS

 

C10920, C10930, C10940

 

 

C11000

 

ETP

 

C11300, C11400, C11500, C11600

 

STP

 

C12000

 

DLP

1.1.1.1 The product may be furnished from any copper listed unless otherwise specified in the contract or purchase order.

1.2 The product for general applications shall be made from any of the coppers in 1.1.1 or the following coppers:

Copper UNS No.3

Reference Designation

 

C10800

 OFLP

C12200

DHP

1.2.1 The product may be furnished from any copper listed above unless otherwise specified in the contract or purchase order. Other coppers may be used upon agreement between supplier and purchaserer.

1.3 Units—The values stated in either inch-pound units or in SI units are to be regarded separately as the standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.

Note 1: Material for hot forging will be found in Specification B124/B124M.

Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 02.01
Developed by Subcommittee: B05.02
Pages: 9
DOI: 10.1520/B0187_B0187M-15
ICS Code: 29.050; 77.150.30