Standard Historical Last Updated: Dec 31, 2010 Track Document
ASTM B161-05e1

Standard Specification for Nickel Seamless Pipe and Tube

Standard Specification for Nickel Seamless Pipe and Tube B0161-05E01 ASTM|B0161-05E01|en-US Standard Specification for Nickel Seamless Pipe and Tube Standard new BOS Vol. 02.04 Committee B02
$ 66.00 In stock

Abstract

This specification covers the standard requirements for nickel (UNS N02200) and low-carbon nickel (UNS N02201) in the form of cold-worked seamless pipe and tube. The material shall conform to the specified chemical composition limits for nickel, copper, iron, manganese, carbon, silicon, and sulfur which shall be determined by chemical analysis. Tension test shall be performed; wherein, the tensile properties for the material specified as small-diameter and light-wall tube shall be in conformity with the tensile strength, yield strength, and elongation requirements. Each pipe or tube shall also be subjected to nondestructive electric test or hydrostatic test in accordance with a referenced ASTM document to determine the allowable fiber stress for the annealed and stress-relieved materials.

Scope

1.1 This specification covers nickel (UNS N02200)* and low-carbon nickel (UNS N02201)* in the form of cold-worked seamless pipe and tube in the conditions shown in Table 1 and Table X1.1.

1.1.1 Hot-worked material is available. Properties are to be agreed upon between the manufacturer and purchaser.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Material Safety Data Sheet (MSDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations.

TABLE 1 Mechanical Properties

Condition and SizeTensile Strength, min, psi (MPa) Yield Strength (0.2 % offset), min, psi (MPa)Elongation in 2 in. or 50 mm (or
4 D), min, %
Nickel (UNS N02200)Low-Carbon Nickel
(UNS N02201)
Nickel (UNS N02200)Low-Carbon Nickel
(UNS N02201)
Nickel (UNS
N02200)
Low-Carbon
Nickel (UNS
N02201)
Annealed:
5 in. (127 mm) and under
outside diameter
55 000 (380)50 000 (345)15 000 (105) 12 000 (80)3535
Over 5 in. (127 mm) in
outside diameter
55 000 (380)50 000 (345)12 000 (80) 10 000 (70)4040
Stress-Relieved:
All sizes65 000 (450) 60 000 (415) 40 000 (275) 30 000 (205)15 15
Price:
Contact Sales
Related
Reprints and Permissions
Reprints and copyright permissions can be requested through the
Copyright Clearance Center
Details
Book of Standards Volume: 02.04
Developed by Subcommittee: B02.07
Pages: 4
DOI: 10.1520/B0161-05E01
ICS Code: 77.150.40