ASTM B130-08

    Standard Specification for Commercial Bronze Strip for Bullet Jackets


      Format Pages Price  
    PDF 6 $51.60   ADD TO CART


    1. Scope

    1.1 This specification establishes general requirements for (commercial bronze) strip for manufacture of bullet jacket cups and ammunition components from Copper Alloy UNS No. C22000.

    1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    B248/B248M Specification for General Requirements for Wrought Copper and Copper-Alloy Plate, Sheet, Strip, and Rolled Bar

    B601 Classification for Temper Designations for Copper and Copper Alloys--Wrought and Cast

    B846 Terminology for Copper and Copper Alloys

    E3 Guide for Preparation of Metallographic Specimens

    E8/E8M Test Methods for Tension Testing of Metallic Materials

    E18 Test Methods for Rockwell Hardness of Metallic Materials

    E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications

    E112 Test Methods for Determining Average Grain Size

    E255 Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition

    E478 Test Methods for Chemical Analysis of Copper Alloys

    E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)


    ICS Code

    ICS Number Code 77.150.30 (Copper products)

    UNSPSC Code

    UNSPSC Code 30262702(Bronze strip); 46181502(Bullet proof vests)


    Referencing This Standard

    DOI: 10.1520/B0130-08

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM B130-08, Standard Specification for Commercial Bronze Strip for Bullet Jackets, ASTM International, West Conshohocken, PA, 2008, www.astm.org

    Back to Top