1. Scope
1.1 This specification establishes general requirements for (commercial bronze) strip for manufacture of bullet jacket cups and ammunition components from Copper Alloy UNS No. C22000.
1.2 Values stated in inch-pound units are to be regarded as the standard except for grain size which is stated in metric units. SI values given in parentheses are for information only.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
B248 Specification for General Requirements for Wrought Copper and Copper-Alloy Plate, Sheet, Strip, and Rolled Bar
B601 Classification for Temper Designations for Copper and Copper Alloys--Wrought and Cast
B846 Terminology for Copper and Copper Alloys
E3 Guide for Preparation of Metallographic Specimens
E8 Test Methods for Tension Testing of Metallic Materials
E18 Test Methods for Rockwell Hardness of Metallic Materials
E29 Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications
E112 Test Methods for Determining Average Grain Size
E255 Practice for Sampling Copper and Copper Alloys for the Determination of Chemical Composition
E478 Test Methods for Chemical Analysis of Copper Alloys
E527 Practice for Numbering Metals and Alloys in the Unified Numbering System (UNS)
Keywords
ammunition components; bronze; bullet jackets; strip; UNS No. C22000; Ammunition; Brass; Bronze; Bullet jackets; Commercial bronze; Copper alloy--specifications; Copper alloy plate/sheet/strip/rolled bar--specifications; UNS C22000 (commercial bronze, 80%);
ICS Code
ICS Number Code 77.150.30 (Copper products)
DOI: 10.1520/B0130-02
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
