SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|5||$52.80||  ADD TO CART|
1.1 This specification establishes the requirements for copper and copper alloy rod, bar, and shapes intended for hot forging. The following coppers and copper alloys are involved:
|Copper UNS Nos.||Copper Alloy UNS Nos.|
Note 1—Additional information about forging practice and forgings produced from these alloys is given in Appendix X1 and in Specification B283.
1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
B249/B249M Specification for General Requirements for Wrought Copper and Copper-Alloy Rod, Bar, Shapes and Forgings
B283/B283M Specification for Copper and Copper-Alloy Die Forgings (Hot-Pressed)
E54 Test Methods for Chemical Analysis of Special Brasses and Bronzes
E62 Test Methods for Chemical Analysis of Copper and Copper Alloys (Photometric Methods)
E75 Test Methods for Chemical Analysis of Copper-Nickel and Copper-Nickel-Zinc Alloys
E76 Test Methods for Chemical Analysis of Nickel-Copper Alloys
E121 Test Methods for Chemical Analysis of Copper-Tellurium Alloys
E478 Test Methods for Chemical Analysis of Copper Alloys
Other StandardsISO 3110, Part 2 (TC 26 Ref. No. N 670 E/F) Determination of Aluminum Content: Flame Atomic Absorption Spectrometric Method Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036, http://www.ansi.org. JIS H 1068:2005 Methods for Determination of Bismuth in Copper and Copper Alloys Available from Japanese Standards Association (JSA), Mita MT Bldg., 3-13-12 Mita, Minato-ku, Tokyo, 108-0073, Japan, http://www.jsa.or.jp. (Japanese Industrial Standards)
UNSPSC Code 30262200(Copper bars); 30102409(Copper rods)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM B124 / B124M-09, Standard Specification for Copper and Copper Alloy Forging Rod, Bar, and Shapes, ASTM International, West Conshohocken, PA, 2009, www.astm.orgBack to Top