ASTM B108-02

    Historical Standard: ASTM B108-02 Standard Specification for Aluminum-Alloy Permanent Mold Castings

    SUPERSEDED (see Active link, below)


    Buy Standard (PDF)
    13 pages
    $57.60

    Active (view current version of standard)


    1. Scope

    1.1 This specification covers aluminum-alloy permanent mold castings designated as shown in Table 1.

    1.2 Alloy and temper designations are in accordance with ANSI H35.1. The equivalent unified numbering system alloy designations are in accordance with Practice E 527.

    1.3 For acceptance criteria for inclusion of new aluminum and aluminum alloys and their properties in this specification, see Annex A1 and Annex A2.

    1.4 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets.The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

    1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    ICS Code

    ICS Number Code 77.150.10 (Aluminium products)

    UNSPSC Code

    UNSPSC Code 31121300(Machined permanent mold castings); 31101706(Aluminum permanent mold casting)


    DOI: 10.1520/B0108-02

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top