ASTM A995/A995M-09

    Standard Specification for Castings, Austenitic-Ferritic (Duplex) Stainless Steel, for Pressure-Containing Parts

    SUPERSEDED (see Active link, below)


      Format Pages Price  
    PDF Version 3 $44.40   ADD TO CART


    1. Scope

    1.1 This specification covers austenitic-ferritic (duplex) stainless steel castings for valves, flanges, fittings, and other pressure-containing parts.

    1.2 The duplex stainless steels offer a combination of enhanced mechanical properties and corrosion resistance when properly balanced in composition and properly heat treated. Ferrite levels are not specified, but these grades will develop a range of approximately 30 to 60 % ferrite with the balance austenite. It is the responsibility of the purchaser to determine which grade shall be furnished depending on design and service conditions, mechanical properties, and corrosion-resistant characteristics.

    Note 1—Because of the possibility of precipitation of embrittling phases, the grades included in this specification are not recommended for service at temperatures above 600°F [315°C].

    1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A488/A488M Practice for Steel Castings, Welding, Qualifications of Procedures and Personnel

    A703/A703M Specification for Steel Castings, General Requirements, for Pressure-Containing Parts

    E125 Reference Photographs for Magnetic Particle Indications on Ferrous Castings

    E165 Practice for Liquid Penetrant Examination for General Industry

    E562 Test Method for Determining Volume Fraction by Systematic Manual Point Count


    ICS Code

    ICS Number Code 77.140.80 (Iron and steel castings)

    UNSPSC Code

    UNSPSC Code 31100000(Castings and casting assemblies)


    DOI: 10.1520/A0995_A0995M-09

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top