SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|10||$52.80||  ADD TO CART|
1.1 Shape is a significant quality characteristic for tin mill products. Plate-shape is affected by mill process factors plus the temper, thickness and width of the material supplied. It is the purpose of this test method to define accurately the different plate shape characteristics and to describe the method(s) most commonly used to measure particular characteristics.
1.2 Quantitative limits are not addressed and should be established on an individual producer and use basis, where appropriate.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A599/A599M Specification for Tin Mill Products, Electrolytic Tin-Coated, Cold-Rolled Sheet
A623 Specification for Tin Mill Products, General Requirements
A623M Specification for Tin Mill Products, General Requirements [Metric]
A624/A624M Specification for Tin Mill Products, Electrolytic Tin Plate, Single Reduced
A625/A625M Specification for Tin Mill Products, Black Plate, Single-Reduced
A626/A626M Specification for Tin Mill Products, Electrolytic Tin Plate, Double Reduced
A650/A650M Specification for Tin Mill Products, Black Plate, Double Reduced
A657/A657M Specification for Tin Mill Products, Black Plate Electrolytic Chromium-Coated, Single and Double Reduced
ICS Number Code 77.140.50 (Flat steel products and semi-products)
UNSPSC Code 73181108(Tin plating service)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM A987-05, Standard Test Method for Measuring Shape Characteristics of Tin Mill Products, ASTM International, West Conshohocken, PA, 2005, www.astm.orgBack to Top