SUPERSEDED (see Active link, below)
Active (view current version of standard)
1.1 This specification covers stainless steel forgings for compressor and turbine bucket, blade, and airfoil applications.
1.2 This specification is expressed in both inch-pound units and in SI units; however, unless the purchase order or contract specifies the applicable M designation (SI units), the inch-pound units shall apply. The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A275/A275M Practice for Magnetic Particle Examination of Steel Forgings
A788/A788M Specification for Steel Forgings, General Requirements
E112 Test Methods for Determining Average Grain Size
E292 Test Methods for Conducting Time-for-Rupture Notch Tension Tests of Materials
E381 Method of Macroetch Testing Steel Bars, Billets, Blooms, and Forgings
E562 Test Method for Determining Volume Fraction by Systematic Manual Point Count
ICS Number Code 77.140.85 (Iron and steel forgings)
UNSPSC Code 31132600(Stainless steel forgings)