ASTM A971-00

1.1 This test method provides a procedure for measuring edge taper and crown of flat-rolled electrical steel coils as produced at the steel mill.

1.2 The values stated in either customary (cgs-emu and inch-pound) units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with this test method.

1.3 The following material specifications include requirements for edge taper or crown: A677, A677M, A683/A683M, A726, A840, A840M, and A876/A876M.

1.4This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

coupon; crown; edge taper; edge trim; gamma strip; master coil; slit coil;

ICS Code

ICS Number Code 77.140.50 (Flat steel products and semi-products)

Citing ASTM Standards

[Back to Top]