1. Scope
1.1 This specification covers masonry joint reinforcement fabricated from cold-drawn steel wire. Joint reinforcement consists of longitudinal wires welded to cross wires.
1.2 The values stated in inch-pound or SI units are to be regarded as standard. Within the text the inch-pound units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values may result in nonconformance with the specification.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A82/A82M Specification for Steel Wire, Plain, for Concrete Reinforcement
A152 Specification for Wrought Iron Rivets and Rivet Rounds
A185/A185M Specification for Steel Welded Wire Reinforcement, Plain, for Concrete
A496/A496M Specification for Steel Wire, Deformed, for Concrete Reinforcement
A580/A580M Specification for Stainless Steel Wire
A641/A641M Specification for Zinc-Coated (Galvanized) Carbon Steel Wire
A1064/A1064M Specification for Steel Wire and Welded Wire Reinforcement, Plain and Deformed, for Concrete
Keywords
cross wires; deformed; galvanized wire; hot-dipped galvanized; joint reinforcement; ladder type; longitudinal wires; tensile properties; truss type; weld shear strength: Masonry joint reinforcement; Masonry units--specifications;
ICS Code
ICS Number Code 91.080.30 (Masonry)
DOI: 10.1520/A0951_A0951M-06
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
