1. Scope
1.1 This specification covers structural steel H-piles and sheet piling with protective fusion-bonded epoxy coating applied by the electrostatic spray, flocking, or fluidized bed process.
Note 1—The coating applicator is identified throughout this specification as the manufacturer.
1.2 Requirements for coatings are contained in .
1.3 This specification is applicable for orders in either inch-pound units (as Specification A 950) or SI units (as Specification A 950M). The values stated in either inch-pound or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets.
1.4 This standard does not purport to address any of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A6/A6M Specification for General Requirements for Rolled Structural Steel Bars, Plates, Shapes, and Sheet Piling
A36/A36M Specification for Carbon Structural Steel
A328/A328M Specification for Steel Sheet Piling
A572/A572M Specification for High-Strength Low-Alloy Columbium-Vanadium Structural Steel
A588/A588M Specification for High-Strength Low-Alloy Structural Steel, up to 50 ksi [345 MPa] Minimum Yield Point, with Atmospheric Corrosion Resistance
A690/A690M Specification for High-Strength Low-Alloy Nickel, Copper, Phosphorus Steel H-Piles and Sheet Piling with Atmospheric Corrosion Resistance for Use in Marine Environments
A857/A857M Specification for Steel Sheet Piling, Cold Formed, Light Gage
B117 Practice for Operating Salt Spray (Fog) Apparatus
G8 Test Methods for Cathodic Disbonding of Pipeline Coatings
G12 Test Method for Nondestructive Measurement of Film Thickness of Pipeline Coatings on Steel
G14 Test Method for Impact Resistance of Pipeline Coatings (Falling Weight Test)
G20 Test Method for Chemical Resistance of Pipeline Coatings
National Association of Corrosion Engineers Standard
TM0175 Visual Standard for Surfaces of New Steel Centrifugally Blast Cleaned with Steel Shot or Steel Grit (Nace No. 2)
American Petroleum Institute Specification
API RP 5L7 Recommended Practice for Internal Fusion Bonded Epoxy Coating of Line Pipe
Keywords
corrosion resistance; fusion-bonded epoxy coating; H-piles; sheet piling; structural steel: Corrosion-resistant steel--specifications; Corrosive service applications; Fusion-bonded epoxy-coated steel materials; H-piles; Organic coatings--specifications; Sheet piling; Structural steel (SS) piles--specifications;
ICS Code
ICS Number Code 77.140.50 (Flat steel products and semi-products); 77.140.60 (Steel bars and rods)
DOI: 10.1520/A0950_A0950M-99R03
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
