ASTM A950/A950M-99

    Standard Specification for Fusion Bonded Epoxy-Coated Structural Steel H-Piles and Sheet Piling

    SUPERSEDED (see Active link, below)


      Format Pages Price  
    PDF Version 5 $50.40   ADD TO CART


    1. Scope

    1.1 This specification covers structural steel H-piles and sheet piling with protective epoxy coating applied by the electrostatic spray, flocking, or fluidized bed process.

    Note 1-The coating applicator is identified throughout this specification as the manufacturer.

    1.2 Other organic coatings may be used provided they meet the requirements of this specification.

    1.3 Requirements for coatings are contained in Annex A1.

    1.4 This specification is applicable for orders in either inch-pound units (as Specification A950) or SI units [as Specification A950M]. The values stated in either inch-pound or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. This specification is applicable for orders in either SI units or inch-pound units.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A6/A6M Specification for General Requirements for Rolled Structural Steel Bars, Plates, Shapes, and Sheet Piling

    A36/A36M Specification for Carbon Structural Steel

    A328/A328M Specification for Steel Sheet Piling

    A572/A572M Specification for High-Strength Low-Alloy Columbium-Vanadium Structural Steel

    A588/A588M Specification for High-Strength Low-Alloy Structural Steel, up to 50 ksi [345 MPa] Minimum Yield Point, with Atmospheric Corrosion Resistance

    A690/A690M Specification for High-Strength Low-Alloy Nickel, Copper, Phosphorus Steel H-Piles and Sheet Piling with Atmospheric Corrosion Resistance for Use in Marine Environments

    A857/A857M Specification for Steel Sheet Piling, Cold Formed, Light Gage

    B117 Practice for Operating Salt Spray (Fog) Apparatus

    G8 Test Methods for Cathodic Disbonding of Pipeline Coatings

    G12 Test Method for Nondestructive Measurement of Film Thickness of Pipeline Coatings on Steel

    G14 Test Method for Impact Resistance of Pipeline Coatings (Falling Weight Test)

    G20 Test Method for Chemical Resistance of Pipeline Coatings

    American Petroleum Institute Specification

    APIRP5L7 Recommended Practice for Internal Fusion Bonded Epoxy Coating of Line Pipe

    National Association of Corrosion Engineers Standard

    TM0175 Visual Standard for Surfaces of New Steel Centrifugally Blast Cleaned with Steel Shot or Steel Grit (Nace No. 2)


    ICS Code

    ICS Number Code 77.140.50 (Flat steel products and semi-products); 77.140.60 (Steel bars and rods)

    UNSPSC Code

    UNSPSC Code 30102803(Steel pilings)


    DOI: 10.1520/A0950_A0950M-99

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top