ASTM A915/A915M-93(2003)

    Standard Specification for Steel Castings, Carbon, and Alloy, Chemical Requirements Similar to Standard Wrought Grades


      Format Pages Price  
    PDF 3 $45.60   ADD TO CART


    1. Scope

    1.1 This specification covers carbon and low alloy steel castings having chemical analyses similar to that of the standard wrought grades.

    1.2 Several grades are covered and are designated by chemical composition shown in Table 1.

    1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. Inch-pound units are applicable for material ordered to Specification A915 and SI units for material ordered to Specification A915M.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A370 Test Methods and Definitions for Mechanical Testing of Steel Products

    A781/A781M Specification for Castings, Steel and Alloy, Common Requirements, for General Industrial Use


    ICS Code

    ICS Number Code 77.140.85 (Iron and steel forgings)

    UNSPSC Code

    UNSPSC Code 31100000(Castings and casting assemblies)


    Referencing This Standard

    DOI: 10.1520/A0915_A0915M-93R03

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM A915 / A915M-93(2003), Standard Specification for Steel Castings, Carbon, and Alloy, Chemical Requirements Similar to Standard Wrought Grades, ASTM International, West Conshohocken, PA, 2003, www.astm.org

    Back to Top