1. Scope
1.1 This specification covers steel wire in the size range of 0.120 to 0.500 in. (3.05 to 12.7 mm) with three classes of protective epoxy coating, in coils, for general use. Class A coating is intended for use for moderate corrosion protection, Class B coating for more severe protection, and Class C for severe corrosion and abrasion protection.
Note 1—The coating applicator is identified throughout this specification as the manufacturer.
<>1.2 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
ASTM Standards
A510 Specification for General Requirements for Wire Rods and Coarse Round Wire, Carbon Steel
A775/A775M Specification for Epoxy-Coated Steel Reinforcing Bars
A853 Specification for Steel Wire, Carbon, for General Use
G12 Test Method for Nondestructive Measurement of Film Thickness of Pipeline Coatings on Steel
Keywords
epoxy coated; wire; Epoxy-coated steel wire specifications; Steel wire (coated) specifications; Epoxy-coated steel wire specifications; Steel wire (coated) specifications;
ICS Code
ICS Number Code 77.140.65 (Steel wire, wir ropes and link chains)
DOI: 10.1520/A0899-91R02
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
