ASTM A897/A897M-02

    Standard Specification for Austempered Ductile Iron Castings

    SUPERSEDED (see Active link, below)


      Format Pages Price  
    PDF 7 $51.60   ADD TO CART


    1. Scope

    1.1 This specification covers ductile iron castings that are subsequently heat treated by an austempering process as defined in 8.1.

    1.2 The application of the austempering heat treatment extends the range of properties achievable in ductile iron castings.

    1.3 No precise quantitative relationship can be stated between the properties of the iron in various locations of the same casting or between the properties of castings and those of a test specimen cast from the same iron (see Appendix X1). However, austempering heat treatment will tend to diminish any differences in mechanical properties.

    1.4 The production of castings, machining (if required), and the austempering heat treatments may be performed by different manufacturers, as covered in Section 13. The purchaser should establish by contract agreement, at the time of ordering, the responsibility of the various parties for meeting the specification requirements.

    1.5 The values stated in either inch-pound or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A247 Test Method for Evaluating the Microstructure of Graphite in Iron Castings

    A370 Test Methods and Definitions for Mechanical Testing of Steel Products

    A732/A732M Specification for Castings, Investment, Carbon and Low Alloy Steel for General Application, and Cobalt Alloy for High Strength at Elevated Temperatures

    A834 Specification for Common Requirements for Iron Castings for General Industrial Use

    E8 Test Methods for Tension Testing of Metallic Materials

    E10 Test Method for Brinell Hardness of Metallic Materials

    E23 Test Methods for Notched Bar Impact Testing of Metallic Materials

    Military Standard

    MIL-STD-129 Military Marking for Shipment and Storage Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http://dodssp.daps.dla.mil.


    ICS Code

    ICS Number Code 77.140.80 (Iron and steel castings)

    UNSPSC Code

    UNSPSC Code 31101618(Ductile iron sand casting)


    DOI: 10.1520/A0897_A0897M-02

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top