1.1 This specification covers precipitation hardening iron base superalloy forgings which are primarily intended for use as turbine rotor disks and wheels.
1.2 Two heat treatments are covered. Selection will depend upon design, service conditions, mechanical properties, and elevated temperature characteristics.
1.3 All of the provisions of Specification A 788/A 788M, apply, except as amended herein.
1.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A788/A788M Specification for Steel Forgings, General Requirements
E112 Test Methods for Determining Average Grain Size
E139 Test Methods for Conducting Creep, Creep-Rupture, and Stress-Rupture Tests of Metallic Materials
E165 Practice for Liquid Penetrant Examination for General Industry
E292 Test Methods for Conducting Time-for-Rupture Notch Tension Tests of Materials
age hardened; alloy steelturbine disk; alloy steelturbine wheel; creep; elevated temperature service; forging; precipitation hardened; stress rupture; superalloy; Forgings--specifications; Forgings (turbine rotors/disks/shafts); Generator materials--turbine; Alloy steel forgings--specifications; Iron alloys--specifications; Iron-base superalloy forgings; Precipitation-hardening metals/alloys--specifications; Superalloy steels--specifications; Turbine rotors/shafts ;
ICS Number Code 77.140.85 (Iron and steel forgings)
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]