ASTM A832/A832M-99

    Standard Specification for Pressure Vessel Plates, Alloy Steel, Chromium-Molybdenum-Vanadium


      Format Pages Price  
    PDF 4 $45.60   ADD TO CART


    1. Scope

    1.1 This specification covers chromium-molybdenum-vanadium alloy steel plates intended primarily for the fabrication of welded pressure vessels.

    1.2 The plates furnished under this specification are required to be normalized-and-tempered. Specification A542/A542M includes coverage of the material in the quenched-and-tempered condition.

    1.3 The maximum thickness of plates furnished to this specification is limited only by the capacity of the composition to meet the specified property requirements. However, the maximum thickness of plates normally furnished under this specification is 6 in. [150 mm].

    1.4 The material is intended to be suitable for fusion welding. Welding technique is of fundamental importance and it is presupposed that welding procedures will be in accordance with approved methods.

    1.5 This specification is expressed in both inch-pound units and in SI units. However, unless the order specifies the applicable "M" specification designation (SI units), the material shall be furnished to inch-pound units.

    1.6 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A20/A20M Specification for General Requirements for Steel Plates for Pressure Vessels

    A370 Test Methods and Definitions for Mechanical Testing of Steel Products

    A435/A435M Specification for Straight-Beam Ultrasonic Examination of Steel Plates

    A542/A542M Specification for Pressure Vessel Plates, Alloy Steel, Quenched-and-Tempered, Chromium-Molybdenum, and Chromium-Molybdenum-Vanadium

    A577/A577M Specification for Ultrasonic Angle-Beam Examination of Steel Plates

    A578/A578M Specification for Straight-Beam Ultrasonic Examination of Rolled Steel Plates for Special Applications


    UNSPSC Code

    UNSPSC Code 30102204(Steel plate)


    Referencing This Standard

    DOI: 10.1520/A0832_A0832M-99

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM A832 / A832M-99, Standard Specification for Pressure Vessel Plates, Alloy Steel, Chromium-Molybdenum-Vanadium, ASTM International, West Conshohocken, PA, 1999, www.astm.org

    Back to Top