SUPERSEDED (click for Active standard)
| ||Format||Pages||Price|| |
|4||$46.80||  ADD TO CART|
1.1 This specification covers structural quality alloy steel plates.
1.2 The plates are usually specified to chemical composition requirements, but tensile properties may also be specified.
1.2.1 When tensile properties are required, the specific requirements must be compatible with the chemical composition, condition, and plate thickness.
1.3 The plates are available in the following four conditions:
1.3.1 Condition AR--As rolled (hot rolled),
1.3.2 Condition A--Annealed,
1.3.3 Condition N--Normalized, and
1.3.4 Condition NT--Normalized and tempered.
1.4 The plates are available in the following three forms:
1.4.1 Form I--Rectangular,
1.4.2 Form II--Circular and semi-circular, and
1.4.3 Form III--Sketch, including rings.
1.5 The plates are available in the following five edge categories:
1.5.1 Edge 1--Mill edge,
1.5.2 Edge 2--Universal mill edge,
1.5.3 Edge 3--Sheared edge,
1.5.4 Edge 4--Gas cut edge, and
1.5.5 Edge 5--Special cut edge.
1.6 The plates are available in the following seven finishes:
1.6.1 Finish 1--As rolled (hot rolled),
1.6.2 Finish 2--Blast cleaned,
1.6.3 Finish 3--Blast cleaned and oiled,
1.6.4 Finish 4--Pickled,
1.6.5 Finish 5--Pickled and oiled,
1.6.6 Finish 6--Painted, one prime coat, and
1.6.7 Finish 7--Painted, one prime coat and one finish coat.
1.6.8 The plates are usually specified to have Finish 1.
1.7 Supplementary requirements are provided for additional requirements that may be specified on the order.
1.8 When the steel is to be welded, it is presupposed that a welding procedure suitable for the grade of steel and intended use or service will be utilized. See Appendix X 3 of Specification A6/A6M for information on weldability.
1.9 The values stated in either inch-pound units or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A6/A6M Specification for General Requirements for Rolled Structural Steel Bars, Plates, Shapes, and Sheet Piling
ICS Number Code 77.140.50 (Flat steel products and semi-products)
UNSPSC Code 30102204(Steel plate)
|Link to Active (This link will always route to the current Active version of the standard.)|
ASTM A829 / A829M-00, Standard Specification for Alloy Structural Steel Plates, ASTM International, West Conshohocken, PA, 2000, www.astm.orgBack to Top