SUPERSEDED (see Active link, below)
| ||Format||Pages||Price|| |
|PDF Version||4||$44.40||  ADD TO CART|
1.1 This specification covers stainless steel floor plates ½ in. and under for use in galley spaces, washrooms, engine rooms, and machinery spaces, and for ladder treads, gun platforms, and deck treads. For these uses, Patterns A, B, and C are considered interchangeable (see Fig. 1, Fig. 2, and Fig. 3).
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
FIG. 1 Pattern A (percent of reduction, 61 %)
FIG. 2 Pattern B (original of raised figures approximately 1¼ in., percent of reduction 61 %)
FIG. 3 Pattern C
2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.
A340 Terminology of Symbols and Definitions Relating to Magnetic Testing
A370 Test Methods and Definitions for Mechanical Testing of Steel Products
A480/A480M Specification for General Requirements for Flat-Rolled Stainless and Heat-Resisting Steel Plate, Sheet, and Strip
A700 Practices for Packaging, Marking, and Loading Methods for Steel Products for Shipment
Military StandardsMIL-I-17214 Indicator, Permeability; Low Mu (Go-NoGo) Available from Standardization Documents Order Desk, DODSSP, Bldg. 4, Section D, 700 Robbins Ave., Philadelphia, PA 19111-5098, http://www.dodssp.daps.mil. MIL-STD-163 Preservation of Steel Products for Domestic Shipment (Storage and Overseas Shipment)
ICS Number Code 77.140.20 (Steels of high quality); 77.140.50 (Flat steel products and semi-products)
UNSPSC Code 30102205(Stainless steel plate)