ASTM A742/A742M-03

    Standard Specification for Steel Sheet, Metallic Coated and Polymer Precoated for Corrugated Steel Pipe

    SUPERSEDED (see Active link, below)


      Format Pages Price  
    PDF Version 4 $44.40   ADD TO CART


    1. Scope

    1.1 This specification covers polymer precoated steel sheet for corrugated steel pipe (CSP) which is coated after metallic coating on continuous lines by coil coating (roller coating or laminating) processes. The metallic coating is either zinc, 55 % aluminum-zinc alloy, or zinc-5 % aluminum-mischmetal alloy. Sheet for this purpose is furnished flat in coils, flat in cut lengths, or corrugated in cut lengths, all being protected by a mill-applied polymer coating on both sides.

    1.2 The values stated in either inch-pound units or SI units are to be regarded separately as the standard. Within the text, the SI units are shown in brackets. The values stated in each system are not equivalents; therefore, each system must be used independently of the other.

    1.3 The following precautionary caveat refers only to the test method portion, Section 9, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A929/A929M Specification for Steel Sheet, Metallic-Coated by the Hot-Dip Process for Corrugated Steel Pipe

    D543 Practices for Evaluating the Resistance of Plastics to Chemical Reagents

    D658 Test Method for Abrasion Resistance of Organic Coatings by Air Blast Abrasive

    D1005 Test Method for Measurement of Dry-Film Thickness of Organic Coatings Using Micrometers

    D2794 Test Method for Resistance of Organic Coatings to the Effects of Rapid Deformation (Impact)

    G22 Practice for Determining Resistance of Plastics to Bacteria

    G23 Practice for Operating Light-Exposure Apparatus (Carbon-Arc Type) With and Without Water for Exposure of Nonmetallic Materials

    G62 Test Methods for Holiday Detection in Pipeline Coatings


    ICS Code

    ICS Number Code 77.140.50 (Flat steel products and semi-products)

    UNSPSC Code

    UNSPSC Code 40170000(Pipe piping and pipe fittings)


    DOI: 10.1520/A0742_A0742M-03

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top