ASTM A735/A735M-03(2007)

    Standard Specification for Pressure Vessel Plates, Low-Carbon Manganese-Molybdenum-Columbium Alloy Steel, for Moderate and Lower Temperature Service

    SUPERSEDED (see Active link, below)


      Format Pages Price  
    PDF 3 $44.40   ADD TO CART


    1. Scope

    1.1 This specification covers low-carbon manganese-molybdenum-columbium alloy steel plates for piping components and welded pressure vessels.

    1.2 Four different classes are covered, which provide various tensile strength properties. A Charpy V-notch energy absorption requirement of 20 ft·lbf [27J] at 50°F [45°C] is specified for all grades.

    1.2.1 Classes 1 and 2 provide minimum yield strength levels of 65 ksi [450 MPa] and 70 ksi [485 MPa] respectively. Both classes can be provided in the as-rolled condition or in the quenched-and-tempered condition.

    1.2.2 Class 3 provides a minimum yield strength level of 75 ksi [515 MPa]. This grade can be provided in the as-rolled and precipitation heat-treated condition or in the quenched-and-tempered condition.

    1.2.3 Class 4 provides a yield strength level of 80 ksi [550 MPa] in the as-rolled and precipitation heat-treated condition.

    1.3 Current practice limits plate thickness furnished under this specification. The individual manufacturer should be consulted on size and thickness limitations.

    1.4 Welding procedures are of fundamental importance and must be such as not to adversely affect the properties of the material, especially in the heat-affected zone. It is presupposed that welding procedures will be suitable for the materials being welded.

    1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A20/A20M Specification for General Requirements for Steel Plates for Pressure Vessels

    A435/A435M Specification for Straight-Beam Ultrasonic Examination of Steel Plates

    A577/A577M Specification for Ultrasonic Angle-Beam Examination of Steel Plates

    A578/A578M Specification for Straight-Beam Ultrasonic Examination of Rolled Steel Plates for Special Applications


    ICS Code

    ICS Number Code 77.140.30 (Steels for pressure purposes)

    UNSPSC Code

    UNSPSC Code 30102204(Steel plate)


    DOI: 10.1520/A0735_A0735M-03R07

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top