ASTM A724/A724M-04

    Standard Specification for Pressure Vessel Plates, Carbon-Manganese-Silicon Steel, Quenched and Tempered, for Welded Layered Pressure Vessels

    SUPERSEDED (see Active link, below)


      Format Pages Price  
    PDF 3 $44.40   ADD TO CART


    1. Scope

    1.1 This specification covers three grades of carbon-manganese-silicon steel, designated Grades A, B, and C. Grade C may be produced with a boron addition. The plates are quenched and tempered and are intended for welded-layered pressure vessels.

    1.2 The maximum thickness of plates supplied under this specification is limited only by the capability of the chemical composition to meet the specified mechanical requirements. However, current practice normally limits the maximum thickness to 7/8in. [22 mm] for Grades A and B, and to 2 in. [50 mm] for Grade C.

    1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A20/A20M Specification for General Requirements for Steel Plates for Pressure Vessels


    ICS Code

    ICS Number Code 77.140.30 (Steels for pressure purposes)

    UNSPSC Code

    UNSPSC Code 30102204(Steel plate )


    DOI: 10.1520/A0724_A0724M-04

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top