1. Scope
1.1 This specification covers uncoated high-strength steel bars intended for use in pretensioned and post-tensioned prestressed concrete construction or in prestressed ground anchors. Bars are of a minimum ultimate tensile strength level of 1035 MPa (150000 psi).
1.2 Two types of bars are provided: Type I bar has a plain surface and Type II bar has surface deformations.
1.3 Supplementary requirements of an optional nature are provided. They shall apply only when specified by the purchaser.
1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
2. Referenced Documents (purchase separately) 
The documents listed below are referenced within the subject standard but are not provided as part of the standard.
U.S. Federal Standards
Government Standards
MIL-STD-129 Marking for Shipment and Storage
ASTM Standards
A370 Test Methods and Definitions for Mechanical Testing of Steel Products
A700 Practices for Packaging, Marking, and Loading Methods for Steel Products for Shipment
E30 Test Methods for Chemical Analysis of Steel, Cast Iron, Open-Hearth Iron, and Wrought Iron
Keywords
deformed bars; high-strength steel bars; plain bars ; post-tensioning; prestressed concrete; High-strength structural steel--specifications; Prestressed concrete; Steel bars (concrete reinforcement- specifications); Uncoated steel
ICS Code
ICS Number Code 77.140.15 (Steels for reinforcement of concrete)
DOI: 10.1520/A0722_A0722M-07
ASTM International is a member of CrossRef.
Citing ASTM Standards
[Back to Top]
