ASTM A722/A722M-06

    Standard Specification for Uncoated High-Strength Steel Bars for Prestressing Concrete


      Format Pages Price  
    PDF 5 $54.00   ADD TO CART


    1. Scope

    1.1 This specification covers uncoated high-strength steel bars intended for use in pretensioned and post-tensioned prestressed concrete construction or in prestressed ground anchors. Bars are of a minimum ultimate tensile strength level of 1035 MPa (150000 psi).

    1.2 Two types of bars are provided: Type I bar has a plain surface and Type II bar has surface deformations.

    1.3 Supplementary requirements of an optional nature are provided. They shall apply only when specified by the purchaser.

    1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A370 Test Methods and Definitions for Mechanical Testing of Steel Products

    A700 Guide for Packaging, Marking, and Loading Methods for Steel Products for Shipment

    A751 Test Methods, Practices, and Terminology for Chemical Analysis of Steel Products

    Military Standard

    MIL-STD-129 Marking for Shipment and Storage

    U.S. Federal Standard


    ICS Code

    ICS Number Code 77.140.15 (Steels for reinforcement of concrete)

    UNSPSC Code

    UNSPSC Code 30103623(Reinforcing bar or rebar or mesh)


    Referencing This Standard
    Link Here
    Link to Active (This link will always route to the current Active version of the standard.)

    DOI: 10.1520/A0722_A0722M-06

    ASTM International is a member of CrossRef.


    Citation Format

    ASTM A722 / A722M-06, Standard Specification for Uncoated High-Strength Steel Bars for Prestressing Concrete, ASTM International, West Conshohocken, PA, 2006, www.astm.org

    Back to Top