ASTM A720/A720M-02(2007)

    Standard Test Method for Ductility of Nonoriented Electrical Steel

    SUPERSEDED (see Active link, below)


      Format Pages Price  
    PDF 2 $44.40   ADD TO CART


    1. Scope

    1.1 This test method covers determination of ductility utilizing Epstein test strips and a bending device for bending the strip over a predetermined radius. It is intended for commercial silicon-bearing steel sheet or strip of nonoriented types in the thickness range from 0.010 to 0.031 in. [0.25 to 0.79 mm], inclusive.

    1.2 The values and equations stated in customary (cgs-emu and inch-pound) or SI units are to be regarded separately as standard. Within this test method, SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with this test method.

    1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


    2. Referenced Documents (purchase separately) The documents listed below are referenced within the subject standard but are not provided as part of the standard.

    ASTM Standards

    A34/A34M Practice for Sampling and Procurement Testing of Magnetic Materials

    A677 Specification for Nonoriented Electrical Steel Fully Processed Types

    A683/A683M Specification for Nonoriented Electrical Steel, Semiprocessed Types

    E290 Test Methods for Bend Testing of Material for Ductility


    ICS Code

    ICS Number Code 77.140.50 (Flat steel products and semi-products)

    UNSPSC Code

    UNSPSC Code 31380000(Magnets and magnetic materials)


    DOI: 10.1520/A0720_A0720M-02R07

    ASTM International is a member of CrossRef.


    Citing ASTM Standards
    Back to Top